PACKARD BELL LJ77 - Manual (Page 107)

Chapter 3 97
Removing the LCD Bezel
1. See “Removing the LCD Module” on page 71.
2. Remove the four screw caps and six screws (four on the Bezel and two on the Hinge Covers).
3. Starting from the top centre of the bezel, pry the bezel upwards and away from the panel. Move along the top
edge and down each side until all sides of the bezel are removed.
NOTE: If necessary, use a pry to lift up the outside edges of the bezel.
Step Size Quantity Screw Type
LCD Bezel
(red callout)
M2.5*5 4
LCD Bezel
(green callout)
M2*4 2