Planar PE1500 - Manual (Page 6)

PE1500 User’s Manual
4
VGA C
Analog S
DC Power Cable
Adapter
Main Power
DC Jack
Button Function Description
Select
(1) Turn on OSD menu while it is off.
(2) Execute the function selected in the OSD menu.
(3) Hold down for 2 sec will clear OSD menu.
Up (△)
(1) Item selection move upward or user-adjustable value
increasing. (in Main Menu).
(2) Brightness (Direct-key function)
Down (▽)
(1) Item selection move downward, user-adjustable value
decreasing (in Main Menu)
(2) Auto Setup (Direct-key function).
Making the Connections
Before connecting any cables, make sure that the computer and display are turn off.
To connect the power and video signal cables:
1. Locate the AC power adapter with attached power cable.
2. Connect the power cable to the power jack on the back of the display (as shown below).
3. Plug the two-prong power cord into a power outlet, and plug the other end into the AC power
adapter.
Plug the analog video signal cable into the Analog Video Input port on the back of the display
(as shown above).
4. Connect the other end of the video cable into your computer’s video port. (Please check your
computer’s documentation if you’re not sure where the port is located.)
Note: For best display performance, it is strongly recommended that you use Auto Setup to
automatically configure your display’s settings.