Panasonic AJ-HDC27A - Manual (Page 64)

64
Loading a cassette tape
Cassette tapes
1
Check that there are no cables around the cassette
holder or top panel, and set the POWER switch to
ON.
When condensation has formed inside the unit, the
HUMID display lights. Wait until this display is
cleared before proceeding with the intended
operation.
Ejecting the cassette tape
While the power is still on, press the EJECT button to
open the cassette holder, and take out the cassette
tape. If another cassette is not going to be loaded
immediately after this tape is ejected, close the
cassette holder.
Ejecting the cassette when the battery
has no charge
First, set the POWER switch to OFF to turn off the
unit’s power.
Then turn the power back on, and immediately hold
down the EJECT button.
The cassette can be removed when there is still some
power left in the battery. However, do not repeat this
operation.
To prevent accidental erasure
Set the cassette’s tab to SAVE to prevent the
recordings on the tape from being erased accidentally.
POWER: ON
HUMID display
EJECT button
Cassette holder
2
Press the EJECT button.
The cassette holder opens.
3
Insert the cassette tape and press the part marked
with the arrow to close the cassette holder
securely.
Check that there is no slack in the tape of the
cassette.
Checking for tape slack
Gently push in the reel using your finger and turn the
reel in the direction of the arrow. If the reel fails to
turn, it means there is no tape slack.
REC
SAVE