Planet Technology SGSW-2402 - Manual (Page 8)

4
2. HARDWARE DESCRIPTION
This product series provide three different running speed – 10Mbps, 100Mbps, and 1000Mbps in the same
switch and automatically distinguish the speed of incoming connection.
This section describes the hardware features of these Switches. For easier management and control of the
switch, familiarize yourself with its display indicators, and ports. Front panel illustrations in this chapter
display the unit LED indicators. Before connecting any network device to the switch, read this chapter
carefully
There are following option module for expansion:
1-Port 100 Base-FX Intelligent Fiber Module
1-Port Gigabit 1000Base-T Intelligent Switch Module
1-Port Gigabit 1000Base-SX/LX Intelligent Fiber Module
2.1 Front Panel
The Front Panel of the SGSW-2402 Intelligent Switch consists of 24x auto-sensing 10/100Mbps Ethernet
RJ-45 Ports, two optional expansion slots, and Console port. The LED Indicators are also located on the
front panel of the Switch.
SGSW-2402 Switch front panel
2.1.1 LED indicators
SGSW-2402
PWR
Green Lit on: Power on
Lit off: power off
Link Green Lit on: the connection is good
Lit off: the port is disabled or not detecting a link
Mode: (could be three kinds of meaning, varies with the Mode button)
ACT Green Lit on: the connection is good.
Blink: The port is receiving or transmitting data
FDX
Green Lit on: the port run at full-duplex
Blink: Half-Duplex/ Collision
Off: Half-duplex or not connected
100 Green Lit on: run at 100Mbps
Lit off: run at 10Mbps or not connected
2.1.2 Buttons indicators
SGSW-2402
RESET
When press this button, Switch will reboot
MODE Hold the button for at lease 5 seconds and release, the LED will turns to the
next LED in cycle. (ACT
FDX Speed ACT)