Philips Indoor Luminaires - Manual (Page 34)

Philips indoor luminaires 11.33
MultiDim
Lighting Controls
Lighting Controls
operation.This means you can be in
control of your light from the moment
that power is first applied.The Input
unit provides 8-volt free input contacts.
The input unit has three modes of
operation, two of these emulate
push button panels using momentary
contacts, and the third mode is for use
with continuous closure contacts.Like the other controls in the MultiDim
range the input unit is pre-configured
for out-of-box operation.This means
you can be in control of your light from
the moment that power is first applied.
Product ID EOC
DCMD440 INPUT UNIT 731681 99
DCMD440
This MultiDim push-button interface
allows users to connect their own
button panels to the MultiDim system.
For retractive (push-to-make) buttons
only.
Product ID EOC
DCMD444 PUSHBUTTON
INTERFACE
928887 00
DCMD444
The 800 W transistor dimmer (trailing
edge) is a DIN-rail-mounted unit that
can control a maximum load of up to
800 W. It can be connected to mains-
voltage (incandescent) lamps directly,
or to low-voltage (halogen) lamps via
an electronic transformer.
Product ID EOC
DCMD450 DIMMER 800W TE 747914 00
DCMD450
The 1 - 10 V Converter has been
designed to control HF-R ballasts. This
ensures that MultiDim systems are
compatible with and easily integrated
into existing systems. The converter can
switch a maximum of 12 HF-R ballasts.
The analogue 1 - 10 V signal and the
digital DSI signal can control 50 HF-R
ballasts. Product ID EOC
DCMD472 CONVERTER 1-10V 731698 99
DCMD472
This MultiDim relay unit features 4
outputs capable of handling loads of up
to 8 A per output.
Product ID EOC
DCMD494 RELAY UNIT 4x8A 928894 00
DCMD494
Indoor_2008_Chapter_11_LIS.indb 33 20-05-2008 14:29:31