Philips Indoor Luminaires - Manual (Page 17)

Philips indoor luminaires 11.16
Indoor Luminaire based control
Lighting Controls
ActiLume
Compact movement detector to be
used to expand the detection area
of luminaires incorporating ActiLume.
The sensor is connected to the DALI
bus from the ActiLume luminaire and
does not require external power. The
sensor is suitable for both recessed and
surface mounting. Mounting height is
between 2.5 and 3.5 m.
Product ID EOC
LRM8118/00 ACTILUME
EXTENSION SENSOR
730783 99
LRM8118
Simple mode selection tool for
ActiLume (mode 1 and mode 2
selection). Light set point calibrator,
easy to use. Batteries are included.
Product ID EOC
IRT8098/00 ACTILUME
PROGRAMMER
730806 99
IRT8098
Linesense
Light sensor intended for high-bay
mounting (approx. 7.5 m high).
Intended for use with the Linesense
control (ZTX400 MDU-D). An
installation bracket is included. The
sensor is connected to the control
unit with a modular plug-in (RJ-12)
connector cable.
Product ID EOC
LRL8102/00 HIGH BAY SENSR 517209 00
LRL8102/00
High-bay passive infrared movement
detector (mounting height up to 15
m), equipped with an adjustable delay
timer (up to 35 minutes). Can be used
with all three MDU control units. A
dedicated mounting bracket (ZTX400
MB-MDU) is available, into which the
movement detector can be clicked.
Product ID EOC
LRM8117/00 SENSR MOV
DET AISLE 518473 99
LRM8117
Indoor_2008_Chapter_11_LIS.indb 16 20-05-2008 14:28:19