Philips Indoor Luminaires - Manual (Page 16)

Philips indoor luminaires Lighting Controls 11.15
Indoor luminaire based control
ActiLume
Actilume is designed to fit the needs of open plan and cell offices, but can also be
adjusted to other applications. It combines energy-saving functions with simple
possibilities for user interaction. This DALI solution does not require the typical
DALI commissioning procedure, but still allows additional savings from daylight
harvesting when controlling two lighting groups separately. The presence detection
feature also allows the external sensor connection to enlarge the detection area.
The presence and daylight functions allow savings of 50% on electrical energy.
Acti Lume has capabilities for manual interaction by means of a pushbutton or an
IR control.
Luxsense
Luminaires fitted with Luxsense offer the benefit of a comfortable, constant level
of illumination throughout the working day. Moreover, they can provide substantial
energy savings (of between 25 and 50%) when installed near windows, where
natural illumination is usually greatest. They also save further energy by maintaining
the illumination level over the lifetime of the lamp, eliminating the need to set
higher-than-necessary initial lighting levels to compensate for the decrease in lamp
efficiency over time.
Color Variation Control (Personal Light)
Personal Light enables individuals to control the lighting according to their
personal preference.
The desired lighting level and color temperature can be set by remote control
(IRT7090) to suit their working situation, mood and physical condition. CVC is
available for, amongst others, Savio luminaires.
Linesense
Linesense is a luminaire-based control system designed for light-line systems such
as the TTX400 that helps save energy in industrial facilities and warehouses by
switching the lights off when there is nobody.
Linesense consists of a 618 mm piece of trunking, which is fully pre-equipped and
wired and ready to be clicked between the light-line and the electrical connection
unit. High-bay movement detectors are connected with standard RJ-12 cables and
mounted at the right location with the use of dedicated brackets.
Lighting Controls
Indoor_2008_Chapter_11_LIS.indb 15 20-05-2008 14:28:15