Panasonic KX-HGC200 - Manual (Page 18)

18
“ Setting up the Broadband Networking Gateway
3 Enter the Node Name and Network Name in the each field and
select the Channel Number from the drop-down list.
Node Name
Channel Number
FEC
Network Name
[Uninstall] button
The name of the Broadband Networking
Gateway for identification in a network.
The KX-HGC200 is preset to communicate
using the radio frequency channel 6
(2437 MHz). This preset channel can be
changed to channel 1 (2412 MHz) or 11
(2462 MHz) by using the Channel Number
pull-down menu. Normally, using the preset
channel is recommended. If the wireless
communication status is not good, changing the
channel may improve the communication status.
To communicate, all the nodes in a wireless
network must be set the same radio
frequency channel.
The FEC (Forward Error Correction) mechanism
of the Whitecap
™ protocol allows your
KX-HGC200 to correct error packets when data
is transmitted to the other wireless nodes and
contributes to higher throughput.
When you disable this function for one node,
be sure to disable this function for all the
nodes in the wireless network.
To use the KX-HGC200, a network name must
be specified in this entry. For more details, refer
to the next page “About the network name”.
Allows you to reset the Network ID of the
KX-HGC200.