Panasonic DMP-BDT110 - Manual (Page 14)

14
VQT3B58
Wireless Settings
Network Easy Setting
(Home Network Connection Check)
Network Easy Setting (Internet Connection Check)
When you experience
problems with settings
Display Check the following
A conflict with another
device occurred. ≥ Please wait a few moments,
and then try again.
A time out error
occurred.
≥ Setting of the Wireless router
for MAC Address etc.
≥ The signal may be weak.
[BDT110] : Using the USB
extension cable supplied with
the Wireless LAN Adaptor,
adjust the position of the
Wireless LAN Adaptor.
≥ The SSID ( 15) and the
encryption key of the Wireless
router.
≥ Please wait a few moments,
and then try again.
An authentication error
or a time out error
occurred.
A device error occurred.
≥ [BDT110] : Connection of
Wireless LAN Adaptor
≥ Contact our Customer
Service Center or your
nearest dealer.
OK
Wireless Settings
Failed to complete.
A conflict with another device occurred.
Do you want to configure wireless network connection
setting again ?
Yes No Display
Check the
following
1. LAN cable connection or
Wireless setting
: Fail
≥ Connection of
the LAN
cables (
10) 2. IP address setting : Fail
3. Connection to gateway : Fail
1. LAN cable connection or
Wireless setting
: Pass
≥ Connection
and settings
of the hub
and router
≥ Settings of
“IP Address/
DNS
Settings”
(
32)
2. IP address setting : Fail
3. Connection to gateway : Fail
1. LAN cable connection or
Wireless setting
: Pass
2. IP address setting
: Pass or
Home
network
available
3. Connection to gateway : Fail
Display Check the following
Cannot find the
server.
(Error code: B019) ≥ “Primary DNS” and “Secondary
DNS” settings of “IP Address/
DNS Settings” (
32)
Failed to connect to
the server.
(Error code: B020)
≥ The server may be busy or the
service may have been
suspended. Please wait a few
moments, and then try again.
≥ Settings of “Proxy Server
Settings” ( 32) and the router
OK
Network Easy Setting (Home Network Connection Check)
Yes No
Complete.
1. LAN cable connection
2. IP address setting
3. Connection to gateway
LAN cable is not connected.
Please check the connection.
Select “Yes” and press [OK] to check network
connection again. Select “No” and press [OK]
to finish Network Easy Setting.
: Fail
: Fail
: Fail
OK
Network Easy Setting (Internet Connection Check)
Complete.
- Connection to the Internet : Fail(Error code: B019)
Failed the connection test.
Cannot find the server.(Error code: B019)
Please refer to the owner's manual for the cause of
the error and the solution for it.
Press [OK].
VQT3B58~Body_eng.fm 14 ページ ２０１０年１２月１０日 金曜日 午後９時１分