Pioneer PRO-1120HD - Manual (Page 22)

06 Preparation
22
En
Switching between antenna A and B
To watch broadcasts via the two antennas, you can select it by
pressing ANT on the remote control unit.
• While watching a broadcast, press ANT to view the image
received from the other antenna.
• Pressing ANT while watching in the 2-screen mode (TV
image and video image) with TV selected will display the TV
image of the other antenna.
• Pressing ANT while watching in the 2-screen mode with two
TV images displayed will not have any effect.
• Pressing ANT while watching in the 2-screen mode with two
video images displayed will switch the selected screen to a
TV image.
Inserting the cable card
The Media Receiver is equipped with a slot for inserting a cable
card. When you are watching digital and/or High Definition TV
channels over cable, the card allows you to use the POD
service provided by the cable TV company; the POD stands for
Point of Deployment. This service presents various types of
useful information, using HTML text.
1 Confirm that the ANTENNA/CABLE A IN terminal has
been connected with the coaxial cable from the Cable
Converter. See page 21.
2 Hold the tab of the slot cover on the rear of the Media
Receiver, and remove the cover while releasing the tab’s
latch.
Cable
CARD
AUDIO-L
COMPONENT
VIDEO
Y
C B /P B
C R /P R
C R /P R
R-AUDIO-L
VIDEO
S400
INPUT 1
DIGIT
AL OUT
OPTICAL
(TS) INPUT 1
Tab
3 Insert the specified cable card into the Cable CARD slot
as far as it goes.
Cable
CARD
INPUT 3
ANTENNA/
CABLE A IN
VIDEO
VIDEO
R-AUDIO-L
R-AUDIO-L
COMPONENT
VIDEO
Y
Y
C B /P B
C B /P B
C R /P R
C R /P R
S-VIDEO
R-AUDIO-L
R-AUDIO-L
VIDEO
S400
INPUT 1
H
DIGIT AL OUT
OPTICAL
(TS)
NPUT 2
• Be sure to insert only the specified cable card.
• Do not insert a PCMCIA card.