Philips T-SMART DBS-EX23-530 - Manual (Page 80)

Trunk Settings Programming Reference
4-28 DBS-EX23-530 Revised April 2000
Trunk Settings
Parameter Trunk Type
Description Determines whether the trunk circuit is an analog loop start, analog
ground start, analog DID, T1, CID, or ISDN.
Note: For changes to this parameter to take effect, the system
must be powered down, then back up again.
Programming FF2 (1-64)# 21# (0-5)#
Options 0= Loop start
1=Ground start
2=DID
3=T1
4=CID
5=ISDN
Parameter ISDN Data Reset
Description Resets the ISDN settings stored in SRAM (Static Random Access
Memory). The reset restores these settings to default values.
Programming FF1 9# 1# (0-1)#
Note: If you enter a “1,” the following display appears:
CONFIRM
0: NO 1: YES
The purpose of this display is to make sure you want to reset the
data. Enter a 0 or 1, depending on whether you want to complete
or cancel the reset.
0=Do not reset
1=Reset
Options 0=No (retain settings)
1=Yes (clear settings)