Philips T-SMART DBS-EX23-530 - Manual (Page 45)

Quick-Start Programming Before You Begin
Revised April 2000 DBS-EX23-530 3-3
Before You Begin
Before you begin programming, you should be familiar with resetting the
DBS and performing the “ISDN Data Reset” command. The following
paragraphs explain when these two procedures are used.
The ISDN Data Reset command. If you are installing ISDN while you are
upgrading to a new DBS release, perform the “ISDN Data Reset” before you
begin ISDN programming.
Manually Resetting the DBS. Many of the ISDN programs require a manual
reset to take effect. Program all of the quick-start items first, then reset the
system by powering it off then back on.
Note:COP 1.07 or later is required on the PRI Card with CPC-EX 2.2 or later.