Premier Mounts PCM-MS3 - Manual (Page 8)

Page 8 Installation Instructions
PCM-MS3
Step 3. Match the center of viewing guide with the
enter line you marked in step 1.
Step 1. Install two (2) M6 x 30 (mm) Phillip pan screws to the bottom of the left and right hand side mounting brackets.
Step 2. Once the mounting brackets are aligned secure the Griplate™ to the flat panel.
Secure the two (2) M6 x 30 Phillip pan screws to the left and right mounting bracket.
L
C
Securing the Mounting Brackets
Do not over tighten the mounting hardware.
The dimples of the top plates have to be facing up and the bottom dimples must be facing down.
The Griplate™ have M4, M5 M6 and M8
hole patterns to fit the hardware that your
flat panel requires.
EXAMPLE: If your plasma uses
M8 x 20 Phillip screws,
use the M8 mounting
points.
Align the Mounting
Brackets
Step 4. The mounting brackets are designed with a
center of viewing guide on the side of them.
Display
Mounting Bracket
Viewing Guide
Center Line
Screwdriver
Dimples
Facing Up
Dimples
Facing Up
Dimples
Facing Down
Dimples
Facing Down
Dimples
M8
M6
M5
M4