Premier Mounts PSD-CAM - Manual

PSD-CAM
Page - 1 - Installation Instructions
PSD-CAM INSTALLATION INSTRUCTIONS
PSD-CAM (Qty 1)
M8 x 10mm Set
Screw (Qty 2)
1. Place each PSD-CAM shelf over the end of the support poles (Figure 1).
2. Use one (1) M8 x 10mm set screw and attach it in the hole that is located to the rear of each
collar (Figure 2).
3. Use a 5/32” Allen Wrench (supplied) to tighten the set screws (Figure 2).
Figure 1 Figure 2 Figure 3
M10 x 12MM
Set Screws
5/32” Allen
Wrench
PSD-EXT
Support Poles