Premier Mounts PCM-MS3 - Manual (Page 7)

Installation Instructions Page 7
Proper installation procedure by qualifi ed personnel as outlined in the installation instructions must be adhered to. Failure to do
so could result in serious personal injury and possible damage to the fl at panel.
Mount Orientation
Step 1. Once the flat panel is inverted, use a
measuring tape to find the center of your flat
panel measuring from outside to outside of
the chassis.
PCM-MS3
Invert the fl at panel place it on a soft, fl at surface to prevent damage to the fl at panel. Use a blanket, foam, etc. Failure to do so
will result in damaging the fl at panel. Do not lay the fl at panel on the fl oor without any protection to the glass. The fl at panel
is heavy and fragile. At least (2) qualifi ed personnel are strongly recommended for installation of this product. Failure to do so
could result in serious injury and possible damage to the fl at panel.
CL
L
C
Step 2. Using a pencil lightly mark the center of your
flat
panel.
Positioning the Mounting Brackets
If your display has uneven mounting points, or recessed mounting points, please use the provided spacers (Page 5).
Step 1. Install the nylon spacers to the mounting
points on the flat panel.
If the nylon spacers apply to your flat
panel, please see Page 5.
Step 2. Lay the left and right mounting brackets (stamped
arrows facing out).
Top of Flat Panel
Tape Measure
Flat Panel
Bottom of
Flat Panel
Marking the Center
Of the Display
Display
Nylon Spacer
Center Mark
Left Mounting
Bracket
Right Mounting
Bracket
Arrows Facing Out