Premier Mounts Low-Profile Dedicated Projector Mount PDS-016 - Manual

PDS-016 Projector Bracket
Installation Instructions Page 1
Premier Mounts
3130 E. Miraloma Ave.
Anaheim, CA 92806
Phone: (800) 368-9700 Fax: (800) 832-4888
[email protected] www.mounts.com
PDS-016 Projector Bracket Installation Instructions
PDS-016 Bracket
(Qty 1)
M6 x 8mm Phillips
Head Screws
(Qty 3)
1. Invert the projector and place it on a soft and flat surface. Remove any foot
levelers that might possibly prevent the correct installation of the bracket.
2. Locate the three mounting points located on the bottom of the projector.
3. Line up the mounting points on the projector with the mounting holes on
the PDS-016 mounting bracket.
1. Using a screwdriver, secure the PDS-016 mounting bracket using three (3)
M6 x 8mm Phillips Head screws. Do not over tighten these screws.
Overtightening the screws may result in damaging the threaded inserts on
the projector.
NOTE: Please refer to the PDS Base Box Installation Instructions to attach
the PDS Base Box to the PDS-016 mounting bracket.
NOTE: The projector (shown above) is for illustration purposes only.
IN-PDS016.R0
M6 x 8mm Security
Head Screws
(Qty 3)