Polycom SpectraLink 1725-36092-001 - Manual (Page 22)

Polycom® SpectraLink® 6020 Wireless Handset User Guide
October, 2011 | 1725-36729-001_D.docx 22
Chapter 5: Handset Administration
FAQs
How does the handset power off and power on?
The END key is the power on/power off key. Press and hold it to turn the handset on. Turn the handset
off from the standby mode by pressing and holding the END key. If you are in an active call, end the call
by pressing the END key. This returns the handset to the standby mode, then press END again to turn
the handset off.
How do I place a call and terminate a call?
To place a call, press the START key and then dial the number. End the call by pressing the END key. You
can also use the speakerphone instead of the START key.
Can I change the ring?
The ring is fully adjustable and may be set differently for different profiles. For a complete explanation
of how to change the ring, see the Changing Ring Settings section of this guide.
How do I change the voice volume and the ringing volume?
Whether using a headset, the speakerphone, or the internal speaker, the speaker volume for the current
call may be raised or lowered by pressing the up and down volume buttons on the side of the handset.
The volume buttons may be pressed while the handset is ringing to raise or lower the ring volume,
which also changes the ring volume setting in the current profile.
What is the range of the wireless telephone?
As barriers affect radio transmission, there is no single answer for this question. Normally, you can
expect the same range as with any other wireless device. However, if your facility has metal walls or
other materials that inhibit radio waves, the range will be reduced.
How do I charge the Battery Pack?
The Battery Pack in the handset may be charged in a Single or Dual Charger without being removed from
the handset by simply placing the handset into the charger. A spare Battery Pack may be charged in the
rear bay of the Dual Charger or in a Quad Charger.