Pentax IC-360 - Manual (Page 30)

(2) Ethernet Interface:
An administrator may configure the IP address, subnet mask, broadcast address, gateway address,
and DNS addresses of a VersaCam. The administrator may set the broadcast address automatically
by clicking the ‘Get From Netmask’ button after assigning an IP address and subnet mask. An
administrator may also, depending on the network type, set the data packet size with ‘Select MTU
Size’ to utilize the network more effectively.
When the addresses are not assigned properly, users cannot access a VersaCam from any local or
remote network. Even on the local network, a user is not able to access the camera if the
administrator does not assign a proper IP address to the VersaCam.
(3) xDSL Interface
If a VersaCam is connected on an xDSL line that requires a PPPoE process, the administrator should
select ‘xDSL (PPPoE)’ and configure the ID and password for PPPoE. The ID and password may be
acquired from the ISP that installed the line. The VersaCam may get an IP address when it is
connected to the xDSL line.
VersaCam IC-360 User’s Guide 24