Pioneer 2010 NAVIGATION UPGRADE SD-CARD CNSD-130FM - Manual (Page 137)

Symptom Cause Action (Reference)
The person on the other end of
the phone call cannot hear the
conversation due to an echo. The voice from the person on the
other end of the phone call is output
from the speakers and then picked
up by the microphone again, creat-
ing an echo. Use the following methods to reduce the
echo:
—Lower the volume on the receiver
—Have both parties pause slightly before
speaking
There
’s no picture.
The backlight of the LCD panel is
turned off. Turn on the backlight. (Page 124)
There is no response when the
touch panel keys are touched, or
a different key responds. The touch panel keys deviate from
the actual positions that respond to
your touch for some reason. Perform touch panel calibration. (Page 122)
The USB storage device cannot
be used. The USB storage device has been
removed immediately after plugging
it. Park your vehicle in a safe place, and turn off
the engine. Turn the ignition key back to Acc
off. Then start the engine again, and turn the
power to the navigation system back on.
Problems in the audio screen
Symptom Cause Action (Reference)
CD playback is not possible. The disc is inserted upside down. Insert the disc with the label upward.
The disc is dirty. Clean the disc.
The disc is cracked or otherwise da-
maged. Insert a normal, round disc.
The files on the disc are an irregular
file format. Check the file format.
The disc format cannot be played
back. Replace the disc.
The loaded disc is a type this system
cannot play. Check what type of disc it is.
The audio skips. The navigation system is not firmly
secured. Secure the navigation system firmly.
No sounds are produced.
The volume level will not rise. Cables are not connected correctly. Connect the cables correctly.
The system is paused or performing,
fast reverse or forward during the
audio playback. There is no sound on fast reverse or forward.
iPod cannot be operated. The iPod is frozen. ! Reconnect the iPod with the USB interface
cable for iPod.
! Update the iPod software version.
An error has occurred.
! Reconnect the iPod with the USB interface
cable for iPod.
! Park your vehicle in a safe place, and apply
the parking brake. Turn the power off and
then turn the power on. If this does not solve
the problem, press
RESET button on the navi-
gation system.
! Update the iPod software version.
En
137
Appendix
Appendix
Appendix