Pioneer ANH-P9R-BK - Manual (Page 77)

10
Section
Audio Adjustments
En 77
English
Espa
ñ
ol
Deutsch
F
ran
ç
ais
Italiano
Nederlands
Using balance adjustment
You can select a fader/balance setting that pro-
vides an ideal listening environment in all occu-
pied seats.
1 Press AUDIO to select F/B (fader/balance).
2 Press
5 or ∞ to adjust front/rear speaker
balance.
Each press of
5 or ∞ moves the front/rear
speaker balance towards the front or the rear.
• “FADER F15” – “FADER R15” is displayed as
the front/rear speaker balance moves from front
to rear.
• “FADER FR00” is the proper setting when only
two speakers are used.
• When the PREOUT setting is
SW , you cannot
adjust front/rear speaker balance. Refer to
Switching the rear output setting on page 83.
3 Press
2 or 3 to adjust left/right speaker
balance.
Each press of
2 or 3 moves the left/right
speaker balance towards the left or the right.
• “BALANCE L09” – “BALANCE R09” is
displayed as the left/right speaker balance
moves from left to right.
Adjusting equalizer curve
You can adjust the level, the frequency and the
Q factor.
1 Press AUDIO and then press EQ.
2 Press
2 or 3 to select the desired band for
adjustment.
3 Press FREQ to select the desired frequency.
Press
5 or ∞ until the desired frequency
appears in the display.
40 — 80 — 100 — 160 (Hz)
200 — 500 — 1 k — 2 k (Hz)
3.15 k—8 k — 10 k — 12.5 k (Hz)
4 Press LEVEL to select the level.
Each press of
5 or ∞ increases or decreases
the level. +6 – –6 is displayed as the level is
increased or decreased.
5 Press Q to select the desired Q factor.
Press
5 or ∞ until the desired Q factor appears
in the display.
2 N — 1 N — 1 W — 2 W
Note
• If you make adjustments when a curve other
than CSTM2 is selected, CSTM1 curve is
updated.
Level (dB)
Center frequency Frequency (Hz)
Q=2N
Q=2W