Primera Technology LX900 - Manual (Page 37)

Printing 33
Adjust print alignment using the Status Monitor. Go to the
Alignment Tab (third tab).
Three items can be adjusted here:
•
Tear off Position . This value adjusts the position of the last
label printed after it has been presented for tear off. This
only applies if the output mode is set to "Yes" Present the
label. Add to the current value to move the tear point clos-
er to the printer. Subtract from the current value to move
the tear point away from the printer. After adjusting the
value click the Set button to send the value to the printer.
• Left Margin Offset . This value moves the printed label
left or right. Add to the current value to move the printed
label to the right. Subtract from the current value to move
the printed label to the left. After adjusting the value, click
the “Set” button to send the value to the printer. Note:
Before adjusting this value make sure the label stock is
properly loaded so that there is no gap between the edge of
the liner and the fixed throat guide . Any gap at this point
will greatly affect the Left margin offset value
needed to align the label. Also, if you adjust the value with
improperly loaded label stock you will have to adjust it
again if you load the label stock correctly the next time.
• Top of Form ( TOF ). This value moves the print start
position up or down on the label. Add to the current value
to move the printed label down or toward the printer.
Subtract from the current value to move the printed label
up or away from the printer. After adjusting the value click
the “Set” button to send the value to the printer.
LX900.qxd 1/15/2010 8:00 AM Page 33
TOC INDEX TOC TOC INDEX