Primera Technology LX900 - Manual (Page 14)

10 Label Stock
6. Pull the Movable Throat Guide outward to make room for
the label stock.
7. Place the leading edge of the label stock under
the "label stock" symbols on the Throat Guides.
The label stock should be placed far enough into the throat
of the printer to correctly position the Movable Throat
Guide but not yet into the printer itself.
8. Slide the Movable Throat Guide inward until it almost
touches the label stock.
Important Note: The label stock should be close enough to the Fixed and
Movable Thoat Guides to provide proper guidance but not close
enough to pinch the label stock. (0-1 mm gap on either side)
If the label stock is pinched by the guides, poor print quality or
feeding problems could result.
9. Feed the label stock further into the printer until it senses
the label and automatically feeds it through the printer. If
the printer fails to feed the label stock, press the
Load/Feed button on the front panel while continuing to
guide the label stock into the printer. If the printer does not
automatically grab and feed the stock or continues to feed
the stock without stopping check the Stock Sensor position
or mode (Section 2C or 2D).
DO NOT PINCH
Fixed Throat Guide Movable Throat Guide
Label Stock
LX900.qxd 1/14/2010 12:41 PM Page 10
TOC INDEX TOC TOC INDEX