Philips VR605A/58 - Manual (Page 24)

D While a programmed recording is being made, you
cannot operate your video recorder manually. If you
want to cancel the programmed recording, press
STANDBY/ON m .
D If you reach the end of the cassette during a
recording, the video recorder will automatically
eject the cassette.
D If you have put in a cassette that cannot be
recorded on, the cassette will be ejected.
’PROTECTED CASSETTE’ will briefly appear on
the TV screen.
D If the video recorder is switched on a few minutes
before a programmed recording is to start, ’SWITCH
TO STANDBY- TIMER RECORDING’ will flash
on the TV screen.
D If you forget to put a cassette in the machine, ’NO
CASSETTE’ will appear on the TV screen. ’
k ’ will
flash In the video recorder display.
D If ’ALL TIMERS OCCUPIED’ appears on the TV
screen when you press TIMER k , you have used up
all the available TIMER blocks. If you want to clear
or check a programmed recording (TIMER block),
select it with
;P q or rP = .
D If ’DATA ERROR’ briefly appears on the screen, this
means that the TIMER information has not been
transferred. Please check date, start time and end
time of the programmed recording
D Programme numbers ’E1’ and ’E2’ are for
recordings from other sources (through scart socket
AV1 EXT1 or AV2 EXT2 ).
Programming a recording with ’TURBO
TIMER’
With the ’TURBO TIMER’, programming a recording that takes
place within the next 24 hours, will be quick and easy. This
preset information will appear in the display:
•
Programme number = the programme number selected on
your TV
• Start time = current time
• End time = current time + 2 hours
a Press TURBO TIMER on the remote control.
The currently selected programme number will appear in
the display, for instance, ’PROG.
01’. If required, change
the programme number with rP = or ;P q .
01
D If ’CLK’ briefly appears in the display, you must set
the clock. Please read the section ’Setting the time
and date’ in chapter ’INSTALLING YOUR VIDEO
RECORDER’
b Press TURBO TIMER .
The current time (= start time) will appear in the display,
for instance, ’START
20:00’. If required, change the
start time with rP = or ;P q .
20:00
c Press TURBO TIMER .
The end time will appear in the display, for instance,
’END
22:00’. If required, change the end time with
rP = or ;P q .
22:00
d Press TURBO TIMER .
’ OK’ will briefly appear in the video recorder display.
Programming is now complete.
e Make sure that the cassette you have put in can be
recorded on.
f Switch off with STANDBY/ON m .
The programmed recording will only function when the
video recorder is switched off with
STANDBY/ON m .
22