Configuring the ip phone – Perfectone Net Ware IP 300 User Manual
Page 9
IP 300 User Manual
9
CONFIGURING THE IP PHONE
This chapter shows you how to configure the IP phone by keypad, web browser and
telnet. It also tells you the meanings of the items you might encounter in the setting
process.
A. Using the Keypad to Configure the IP phone
Function Keys Introduction:
While using keypad and LCD to configure the
setting of IP phone, following keys will be used:
Keys
Function
Keys
Function
Local IP
Enter change
mode
SPK (Speaker)
Enter submenu; confirm
change
Vol+
Turn over menu
backward
Vol-
Turn over menu forward; move
cursor back in change mode
Keypads
Modify values
Redial
Exit current menu; exit change
mode
Enter setting mode
:
Without picking up the handset, enter the password of the IP phone by pressing the
number buttons (default password is 1234), and then press , hold the button
until appears. Then enter the password again and press
,
the IP phone will enter the setting mode with shown on the screen.
Configure the Network Settings
What if your network is using DHCP Addressing?
The IP Phone is set at the factory for DHCP IP addressing. If your LAN or router uses
DHCP addressing, follow the DHCP procedure in the flow chart below. If you are using
Static IP addresses, follow the Static IP Address Procedure.
(As the IP Phone is preset as DHCP mode, if you use DHCP addressing, no changes is
needed)
SPK