Perfectone Net Ware IP 300 User Manual
Page 18
IP 300 User Manual
18
static ip
: Select this item to authorize users set IP address, subnet mask and
router IP address of IP phone manually.
dhcp
: Select this item to enable DHCP mode. With this system, your LAN or
router automatically assigns all the required network parameters to any device
connected to it when the device log on. IP 300 IP phone is shipped from the
factory with DHCP on. So, if your LAN or router is configured to use DHCP
addressing, the IP phone’s LAN parameters will automatically configure as
soon as it is connected to the LAN or router and powered up.
pppoe
✁
The users using ADSL and Cable Modem may select this item, for it is
a protocol especially designed for them. With this system, ADSL ISP
automatically assigns all the required IP parameters to any device connected
to it when the device log on.
modem
✁
If the IP phone used with modem, please select this item to get
relevant network parameters auto. Then please fill ID and pin into ppp id and
ppp pin fields.
ppp id:
With
pppoe
or
modem
selected in
iptype
drop down list, please enter
the user name here.
ppp pin:
With
pppoe
or
modem
selected in
iptype
drop down list, please enter
the password here.
local ip:
With
static ip
selected in
iptype
drop down list, please enter IP
address of IP phone here.
subnet mask:
With
static ip
selected in
iptype
drop down list, please enter
subnet mask of IP phone here.
router ip:
With
static ip
selected in
iptype
drop down list, please enter router