Perfectone Net Ware IP 300 - Manual (Page 8)

IP 300 User Manual
8
Jack. Plug the other end of the cable into an appropriate LAN or DSL/Cable
router port or a HUB.
3. Power on IP phone: plug the power cord adapter into the Power Jack. Then
plug the other end of the power cord adapter into the appropriate wall outlet.
If your LAN or router is using DHCP, after finishing the above 3 steps, the LCD should display
a series of messages ending with: “Ready for Call” within a few seconds.
Note: If you are not sure whether DHCP service should be present, try the following:
Check with your network administrator to find out if the system uses DHCP,
or
If your IP Phone is connecting with a router, check to see whether it is
configured to provide DHCP addressing.
If your LAN uses static addressing, “Waiting Logon” will display until you enter the IP
Phone’s network settings. Step-by-step instructions for configuring your IP Phone are
provided in Section 3: Configuring the IP Phone of this manual.