Pioneer Elite PureVision PRO 1140HD - Manual (Page 72)

72
En
Using External Equipment 12
Connecting control cables
Connect control cables between the Plasma Display and other
PIONEER equipment having the
logo. These control cables
carry commands from a Pioneer device through its remote
control to the remote control sensor on the Plasma Display.
After the CONTROL IN terminals have been connected, the
remote control sensors on the device does not accept
commands from the remote control. Point the remote control
at the remote control sensor on the Plasma Display to operate
the device.
NOTE
• Make sure that the power is turned Off when connecting
cables.
• Connect all components before plugging cables into the
panel.
About SR+
The CONTROL OUT terminal on the rear of the Plasma Display
supports
SR+. This terminal supports linked operations with a
PIONEER AV receiver. SR+ includes functions such as input
switch linkage operation and DSP surround display. For more
information, see the Pioneer AV receiver’s operating
instructions regarding
SR+ support.
NOTE
• When connecting control cables, use the SR+ cable.
• When connecting one or more Pioneer devices, directly
connect the Plasma Display and an SR+ supported Pioneer
amplifier. Do not daisychain other equipment between the
Pioneer units.
• When operating devices using SR+, volume on the Plasma
Display is lowered temporarily.
Plasma Display (rear view)
CONTROL
IN
OUT
CONTROL
IN
OUT
CONTROL
IN
OUT
When SR+ is not used:
Use mono sound control cables with
mini plugs, no resistance (sold
separately)
When
SR+ is used:
Use the SR+ cable (sold as an option).
PDP_PRO1140HD.book Page 72 Monday, June 5, 2006 5:22 PM