Paradyne 6211-I1 - Manual (Page 39)

6211 ADSL Router User’s Guide
LAN
Local Area Network (LAN) Setup
You can configure the DSL Router IP address and Subnet Mask for the LAN interface to conform your LAN’s IP
Subnet. The Save button only saves the LAN configuration data. The Save/Reboot button saves the LAN
configuration data and reboots the router to make the new configuration effective.
Figure 6-7 LAN Setup
ADSL
There are three major items in the ADSL settings:
Modulation Methods
Six modulation methods for different linking speed are supported by the 6211 ADSL router: G.Dmt Enabled, G.lite
Enabled, T1.413 Enabled, ADSL Enabled, Annex L Enabled, and ADSL2+ Enabled. Set this value as directed by
your ISP.
Phone Line Pair
The 6211 ADSL router supports phone lines on pins 2 and 3 or pins 1 and 4 to connect your telephone set. If your
phone system uses pins 2 and 3, attach a normal RJ11 cable to the router and select “Inner pair” on the screen; if your
phone system uses pins 1 and 4, attach the phone with the supplied RJ11 cable and select “Outer pair” on the screen.
Capacity
The bitswap function removes bits from the carrier with the lowest signal-to-noise ratio and transfers the bits to
the carrier with the highest signal-to-noise ratio.
6211-A2-GB21-00 November 2004 39