Pride Mobility Jazzy Select 14 - Manual (Page 21)

Jazzy Select 14 Series www.pridemobility.com 21
WIRE TIE
LOCATIONS
I V . A S S E M B L Y
Seat Installation
It may be necessary to install the seat either prior to
initial operation or after transporting your power chair.
WARNING! Do not pick up the seat
frame by the armrests. They are free to
pivot, and you may lose control of the
seat if they do so.
To install the seat:
1. Set the seat on the seat tower. See figure 10.
2. Push the seat down until the latch engages.
3. Install the controller into one of the armrests.
Tighten the setscrew. See figure 10.
4. Route the controller harness to the rear of the
power base.
5. Plug the controller harness into the controller con-
nector on the power base. See figure 6.
6. Secure the controller harness to the armrest
reciever with wire ties. See figure 11.
MANDATORY! Prevent controller
harness damage! Use correct tie-down
points for controller harness. Avoid
routing the controller harness on the
outside of the armrest pad. Route the
harness under the armrest or toward
the inside of the armrest pad. Use
correct tie-down points for the
controller harness to prevent the
harness from getting caught in the
drive tires, pinched in the seat frame,
or damaged when passing through
doorways.
Figure 10. Seat Installation
SEAT
TOWER
Figure 11. Controller Harness Routing