Panasonic AW-PH400P - Manual (Page 40)

Cable Compensation Unit AW-RC400
40
Parts and their function
; MONITOR1, 2 connectors
The video signals of the cameras selected by the
AW-RP400 pan/tilt control panel or the AW-CB400
remote operation panel which is connected to the
AW-RP400 are output from these connectors.
The output signals are cable-compensated signals of the
same type as the input signals. For instance, if a channel
to which composite signals have been input is selected,
these composite signals will be cable-compensated and
output.
< Y/VIDEO IN connectors [1 to 5]
The analog video signals are input to these connectors.
They are terminated internally by a 75-ohm resistance.
Either Y (component signals or Y of the Y/C signals with
sync) or VIDEO (composite) signals are supplied.
= Pr/C IN connectors [1 to 5]
The analog video signals are input to these connectors.
They are terminated internally by a 75-ohm resistance.
Either Pr (R-Y among the component signals) or C (C of
the Y/C signals) signals are supplied.
> Pb IN connectors [1 to 5]
The analog video signals are input to these connectors.
They are terminated internally by a 75-ohm resistance.
The Pb (B-Y among the component signals) signals are
supplied.
? Y/VIDEO OUT connectors [1 to 5]
The analog video signals are output from these
connectors. Cable-compensated Y or VIDEO (composite)
signals that are in accordance with the input signals are
output. Y signals are output if component Y signals have
been input to the Y/VIDEO IN connectors
[1 to 5], and composite signals are output if composite
signals have been input.
@ Pr/C OUT connectors [1 to 5]
The analog video signals are output from these
connectors. Cable-compensated Pr or C signals that are
in accordance with the input signals are output.
Pr signals are output if Pr signals have been input to the
Pr/C IN connectors [1 to 5], and C signals are output if C
signals have been input.
A Pb OUT connectors [1 to 5]
The analog video signals are output from these
connectors. Cable-compensated Pb signals are output if
Pb signals have been input to the Pb IN connectors
[1 to 5].
B AC adaptor storage space
The AC adaptor can be stored here when the ambient
temperature in the location where the cable
compensation unit has been installed is under 86°F
(30°C). Remove the two screws, and remove the storage
space cover. Stow the AW-PS301 AC adaptor in such a
way that the pull-out cable will not be stressed. Trouble
will occur in the AC adaptor if the ambient temperature
exceeds 86°F (30°C), in which case it should not be
stored in the space.
C Cable clamp
This is used to clamp the cable of the AW-PS301 AC
adaptor in place and prevent it from coming loose.