Panasonic AW-PH400P - Manual (Page 27)

Pan/Tilt Control Panel AW-RP400
AW-RP400
27
Parts and their function
P REMOTE connector
Connect an external unit to this connector to control the
pan/tilt head systems from a PC or other external unit.
Connect the connector to the PC using the AW-CA50T9
RS-232C cable.
Q DC 12V IN socket
Connect the AW-PS505 AC adaptor (sold separately) to
this socket.
R CONTROL OUT TO PAN/TILT HEAD [P1] to [P5]
connectors
Connect these connectors to the IP/RP connectors on the
AW-PH400 indoor pan/tilt heads using 10BASE-T
(equivalent to UTP category 5) straight cables. The
cables can be extended up to a maximum of 500 meters.
S MONI SEL OUT connector
Connect this connector to the MONI SEL OUT connector
on the AW-RC400 cable compensation unit using a
10BASE-T (equivalent to UTP category 5) straight cable.
You can monitor the images of the system selected by
the AW-RP400 from the MONITOR1 connector on the
AW-RC400 and the images of the system selected by the
AW-CB400 from the MONITOR2 connector on the
AW-RC400.
If two AW-RP400 units are connected, you can monitor the
images of the system selected by the master AW-RP400
from the MONITOR1 connector on the AW-RC400 and the
images of the system selected by the slave AW-RP400
from the MONITOR2 connector on the AW-RC400.
T CAMERA CONTROL IN FROM ROP connector
Connect the AW-CB400 remote operation panel to this
connector using the connecting cable packed with the
AW-CB400.
The cameras installed on the pan/tilt heads can now be
controlled from the AW-CB400.
U Ground terminal
Connect this terminal to ground.