Panasonic RAMSA WR-DA7 - Manual (Page 47)

3 - 5
2. Easier Copying of Channel Settings in Multi Channel View.
Previous Versions: The Channel Settings could only be copied from one
channel to another by using the Multi Channel View window. You then had
to press the [COPY] soft button in the LCD display.
Version 2.0: In addition to the method described above, you may also copy
settings for [CHANNEL], [EQ], [DYNAMICS], and [SURROUND] using the
following method as well. Enter the Multi-Channel mode on the DA7 by
pressing the Multi-Channel View button on the Top Panel. This button is
located in the LCD display bridge.
While this window is displayed, press the SELECT button of the channel that
you would like to copy from, then press the SELECT button of the channel
that you would like to copy it to.
Notes: In Multi Channel View, you can not use the short cut ON/OFF of Channel
LINK or STEREO.
3. New LAYER LINK options in TANDEM mode.
Previous Versions: The default setting was ON, therefore the fader layer
selection on one DA7 was duplicated on the Tandem DA7.
Version 2.0: You can select either ON or OFF in the LAYER LINK area of the
[D-IO>SLOT] window. If OFF is selected, the fader layers will not be
duplicated between the two Tandem connected consoles, and you operate
each DA7’s layer selection separately while still in the Tandem mode.
[D-IO>TO SLOT] window