Panasonic RAMSA WR-DA7 - Manual (Page 41)

2 - 1 5
1. Cursor to the desired sub-code area and press the ENTER button.
The sub-code area toggles and appears in inverse video if S/PDIF
is selected, or in normal video if AES/EBU is selected.
2. Set the output switches on the AES/EBU Cards and on the DA7’s
Rear Panel to the same position that the respective sub-code area
is selected to in the DIGITAL OUTPUT SELECT within the [D-IO
INPUT SET] window. These switches set only the electrical
differences of RS-422/110
Ω
for AES/EBU or 0.5 V/75
Ω
for S/PDIF,
while the sub-code areas select the sub-code data in the output
signals. Therefore, for proper operation, the output switch and
the sub-code area for must be in the same position.
37. All Control Change Numbers are available for MIDI Remote mode.
Previous Versions: You could not select MIDI Control Change numbers 6,
38, 96, 97, 98, 99, 100 or 101. They had been reserved by the DA7 operating
system.
Version 2.0: You can now select any Control Change Number up to 119.