Pfaff 1540 User Manual
Page 82
80
46. Changing the toothed belt
Removal:
z
Disconnect the machine lead cord.
z
Remove needle and presser foot.
z
Remove detachable work support.
z
Remove top cover.
z
Switch on bobbin winder.
z
Remove the two Torx screws of the housing insert.
z
Remove the housing insert.
z
Remove the four retaining screws of the baseplate.
z
Place the baseplate aside.
z
Loosen screw 152 in arm shaft crank 153 (fig. 106).
z
Loosen screw 1 on tensioning roller 2.
z
Remove screw 154 on the upper toothed belt sprocket 155.
z
Remove the circlip 156 from the arm shaft.
z
Moving arm shaft 157 to the right, remove the toothed belt for the machine and the toothed belt for the
motor 59.
z
Loosen the three screws 94, 95 and 96 on the automatic utility-stitch unit.
z
Loosen the two screws 101 and remove small gear 97 to the right.
z
Move the automatic utility-stitch unit a little to the front and remove toothed belt 158 between the large
gear and the shaft end.
Refitting:
z
Insert the new toothed belt 158 for the machine between the large gear and the end of the shaft and
mount it on the lower belt sprocket 159.
z
Tighten the three screws 94, 95 and 96 on the automatic utility-stitch unit.
z
Pull toothed belt 158 upwards.
z
Slide arm shaft 157 to the left through toothed belt 158 into the left bearing and arm shaft crank 153.
z
Refit circlip 156 on the arm shaft.
z
Secure the arm shaft and insert screw 152 in the arm shaft crank.
z
Mount toothed belt 158 on the upper belt sprocket 155.
z
Insert screw 154 in the upper belt sprocket and firmly tighten.
z
Adjust tensioning roller in accordance with section 1.
z
Mount toothed belt 59 for the motor on the handwheel.
z
Refit small gear 97 on the shaft and gently tighten screws 101.
z
Adjust the gears in accordance with section 22.