Removing the housing covers – Pfaff 1540 User Manual
Page 10
8
Removing the housing covers
Note:
Before adjusting or repairing the machine, make sure to remove the housing covers as described
in this manual.
z
Disconnect the machine's main plug.
z
Remove needle and presser foot.
z
Remove detachable work support.
z
Remove top cover.
z
Switch on bobbin winder.
z
Remove the two Torx screws of the housing insert..
z
Remove housing insert.
z
Lay the machine on its back and remove the four fastening screws of the baseplate.
z
Remove baseplate.
z
Remove the two fastening screws 1 of free-arm cover (fig. 1).
z
Pull the left-hand side of the free-arm cover a little bit downwards and remove it towards the left.
z
Remove needle plate.
z
Remove the two fastening screws 2 of the upper free-arm cover (fig. 2).
z
Loosen fastening screw 3 of free-arm cover.
z
Remove free-arm cover.