Configuring ds0 channels – Paradyne 3160 User Manual
Page 63
![background image](/manuals/176508/63/background.png)
Operation
3-29
3160-A2-GB21-80
March 1999
Configuring DS0 Channels
The DSU/CSU provides channel configuration options that allow you to do the
following:
H
Display the DS0 assignments for the network, DTE Drop/Insert (DSX-1), and
data port interfaces.
H
Allocate DS0 channels on the DTE Drop/Insert (DSX-1) interface to the
network interface.
H
Allocate DS0 channels on the network or DTE Drop/Insert (DSX-1) interface
to particular data ports.
H
Clear (deallocate) all DS0 channels from the network, DTE Drop/Insert
(DSX-1), or data port interface.
H
Map data from one port to another.
To allocate DS0 channels, begin by defining the logical channel configuration for
the network interface, and then the DTE Drop/Insert (DSX-1) interface, and then
any ports, if desired. See
for an example of a conceptual diagram of a
Blank configuration worksheets are provided at the back of Appendix C,
. To complete the configuration worksheets for DS0 channel
allocation:
1. Complete the Network Interface and the DTE Drop/Insert (DSX-1) Interface
tables (unless the DTE Drop/Insert interface is disabled) as shown in the
examples in
2. Complete the Robbed Bit Signaling (RBS) information worksheet as shown in
3. Using the worksheets shown in
configuration options needed to implement the logical channel configuration.
Once you have completed the worksheets, enter this information using the
procedures in