Pioneer VSX-416-S/-K - Manual (Page 8)

5 minute guide 02
8
En
Using the Quick Setup
You can use the Quick Setup to get your system
up and running with just a few button presses.
The receiver automatically makes the
necessary settings after you have selected your
speaker setup, room size and listening position.
• VSX-516 model only – For a more complete
surround setup, see Automatically setting
up for surround sound (MCACC) on page 9 .
If you want to make more specific settings,
refer to
The System Setup menu on page 34.
Use the front panel controls for the steps below.
Illustration shows the VSX-516 model
1 If the receiver is off, press
STANDBY/ON to turn the power on.
2 Press QUICK SETUP .
3 Confirm your subwoofer setting.
• VSX-416 model – Use the MULTI JOG dial to
select SW YES or SW NO , depending on
whether you’ve connected a subwoofer,
then press
ENTER .
• VSX-516 model – SW DET flashes in the
display while the receiver checks your setup
for a subwoofer.
SW YES or SW NO confirms
the subwoofer check, then the display
prompts you to select your speaker setup.
4 Use the MULTI JOG dial to choose your
speaker setup.
If you selected SW YES ( VSX-416 model ) or
subwoofer was detected ( VSX-516 model ) for
the subwoofer setting in step 3, the following
choices are available:
2.1ch – 3.1ch – 4.1ch – 5.1ch – 6.1ch*
If you selected SW NO ( VSX-416 model ) or
subwoofer wasn’t detected ( VSX-516 model ) for
the subwoofer setting in step 3, the following
choices are available:
2.0ch – 3.0ch – 4.0ch – 5.0ch – 6.0ch*
• Check the table below to find the speaker
setup that corresponds with your system.
* VSX-516 model only
5 Press ENTER .
6 Use the MULTI JOG dial to choose your
room size.
Depending on the distance of your speakers
from the listening position, choose between
small, medium, or large (
S , M or L ), M being an
average-sized room.
7 Press ENTER.
8 Use the MULTI JOG dial to choose your
listening position.
You can cycle between the following choices:
• FWD – If you are nearer to the front
speakers than the surround speakers
• MID – If you are equal distance from the
front and surround speakers
• BACK – If you are nearer to the surround
speakers than the front speakers
9 Press ENTER to confirm your setup.
The display shows the speaker setup, room size
and listening position that you have selected.
STANDBY/ON
PHONES
DVD/LD DVD 5.1 TV / SAT DVR / VCR STANDARD
MIDNIGHT/
LOUDNESS
ADVANCED SURR ST/DIRECT/
AUTO SURR
LISTENING MODE
QUICK
SETUP SETUP RETURN MUTE TONE
ANALOG ATT SPEAKER IMPEDANCE
TUNER EDIT
DIMMER
MULTI JOG
UP DOWN
MULTI JOG
MASTER
VOLUME
ENTER
TUNING STATION SIGNAL
SELECT SB ch PROCESSING ACOUSTIC EQ
MCACC SETUP MIC
AUDIO/VIDEO MULTI-CHANNEL RECEIVER VSX-516
VSX_516.book.fm 8 ページ ２００６年２月２１日 火曜日 午後４時５２分