Additional information 11 – Pioneer VSX-416-S/-K User Manual
Page 51
Additional information
11
51
En
English
Français
Deutsch
Nederlands
Italiano
Español
No sound from surround or
center speakers.
• Connect the speakers properly (refer to page 17).
• Refer to
Speaker setting
on page 38 to check the speaker settings.
• Refer to
Channel level
on page 39 to check the speaker levels.
No sound from surround back
speaker
(VSX-516 model only).
• Refer to
Speaker setting
on page 38 to check the surround back
speaker settings.
• Refer to
Channel level
on page 39 to check the speaker levels.
• Refer to
Using surround back channel processing
on page 31 to
make sure surround back channel processing and the sound mode
are set for surround back sound.
No sound from subwoofer.
• Make sure the subwoofer is switched on.
• If the subwoofer has a volume knob, make sure it’s turned up.
• The Dolby Digital or DTS source you are listening to may not have
an LFE channel.
• Switch the subwoofer setting in
Speaker setting
on page 38 to
YES
or
PLUS
.
• Switch the
LFE Attenuator Setup
on page 40 to
LFEATT 0
or
LFEATT
10
.
Noise during playback of a
cassette deck.
• Move the cassette deck further from your receiver, until the noise
disappears.
No sound is output or a noise
is output when software with
DTS is played back.
• Set the digital volume level of the player to full, or to the neutral
position.
During a playback search,
noise is output from a DTS
compatible CD player.
• This is not a malfunction, but be sure to turn the volume down to
prevent the output of loud noise from your speakers.
Can’t operate the remote
control.
• Replace the batteries (refer to page 5).
• Operate within 7 m, 30° of the remote sensor on the front panel
(refer to page 5).
• Remove the obstacle or operate from another position.
• Avoid exposing the remote sensor on the front panel to direct light.
The display is dark or off.
• Press
DIMMER
on the remote repeatedly to return to the default.
Problem
Remedy
VSX_516.book.fm 51 ページ ２００６年２月２１日 火曜日 午後４時５２分