08 using the tuner, Listening to the radio, Tuning directly to a station – Pioneer VSX-416-S/-K User Manual
Page 41: Saving station presets, Naming station presets, Using the tuner, Using the tuner 08, Chapter 8
Using the tuner
08
41
En
English
Français
Deutsch
Nederlands
Italiano
Español
Chapter 8:
Using the tuner
Listening to the radio
The following steps show you how to tune in to
FM and AM radio broadcasts and memorize
the frequency for recall later.
1
Press AM or FM to select the tuner band.
2
Tune to a station.
There are three ways to do this:
Automatic tuning
– Press and hold
TUNE
+/–
(VSX-516 model)
/
TUNING +/–
(VSX-416
model)
for about a second. Searching
automatically stops at the next station.
Manual tuning
– To change the frequency
one step at a time, press
TUNE +/–
(VSX-
516 model)
/
TUNING +/–
(VSX-416 model)
.
High speed tuning
– Press and hold
TUNE +/–
(VSX-516 model)
/
TUNING +/–
(VSX-416 model)
continuously.
If the signal is weak, press the
(SHIFT +) MPX
(VSX-516 model)
/
MPX
(VSX-416 model)
button
to switch the receiver into mono reception
mode.
Tuning directly to a station
VSX-516 model only
Sometimes, you'll already know the frequency
of the station you want to listen to. In this case,
you can simply enter the frequency directly
using the number buttons on the remote
control.
1
Press FM or AM to select the band.
2
Press (SHIFT +) D.ACCESS (Direct Access).
3
Use the number buttons to enter the
frequency of the radio station.
For example, to tune to
106.00
(FM), press
1
,
0
,
6
,
0
,
0
.
If you make a mistake halfway through, press
(SHIFT +)
D.ACCESS
twice to cancel the
frequency and start over.
Saving station presets
This receiver can memorize up to 30 stations,
stored in three banks of 10 stations each.
1
1
Tune to a station you want to memorize.
2
Press T.EDIT (VSX-516 model) / (SHIFT +)
TUNER EDIT (VSX-416 model).
The display shows
ST. MEMORY
, then a
blinking memory class.
3
Press (SHIFT +) CLASS (VSX-516 model) /
CLASS (VSX-416 model) to select one of the
three classes then press ST +/– (VSX-516
model) / STATION +/– (VSX-416 model) to
select the station preset you want.
Use the
MULTI JOG
dial after pressing
STATION
(front panel) to select station
presets.
4
Press ENTER to store the station.
Naming station presets
You can name your station presets for easy
recall.
1
Choose the preset you want to name.
See
Listening to station presets
below.
Note
1 When saving an FM frequency, the
MPX
setting is also stored.
VSX_516.book.fm 41 ページ ２００６年２月２１日 火曜日 午後４時５２分