Step 3: install the bios package – Promise Technology FastTrak TX2300 User Manual
Page 124
FastTrak TX2200, TX2300 User Manual
118
Step 3: Install the BIOS Package
1.
Boot your PC from the DOS-bootable diskette.
2.
When the A:\> prompt appears, remove the DOS-bootable diskette and
insert the FastTrak Upgrade diskette.
3.
Find your model of FastTrak controller and type corresponding line at the
A:\> prompt:
•
TX2200, type pflash /f 571.bin and press Enter
•
TX2300, type pflash /f 771.bin and press Enter
4.
When the A:\> prompt appears, remove the upgrade diskette and insert the
DOS-bootable diskette.
5.
Reboot your PC from the DOS-bootable diskette.
6.
When the A:\> prompt appears, remove the DOS-bootable diskette and
insert the FastTrak Upgrade diskette.
7.
Find your model of FastTrak controller and type corresponding line at the
A:\> prompt:
•
TX2200, type pflash /f 571.bin and press Enter
•
TX2300, type pflash /f 771.bin and press Enter
8.
When the A:\> prompt appears, remove the FastTrak Upgrade diskette.
9.
Reboot your PC normally.
This completes BIOS upgrade procedure.
Cautions
•
Before you begin, backup any important or useful data.
•
Do NOT skip any steps in the procedure.
•
Do NOT power off your PC during the procedure.
Note
For systems with multiple FastTrak TX Series controllers:
With the new BIOS installed, only the FastTrak in the lowest
numbered PCI slot will appear in the BIOS screen. However, all
properly installed FastTraks will appear in WebPAM.