Pioneer AVIC-D1 - Manual (Page 103)

101
Chapter 8
Customizing the Audio Source Setting
AV
SUB. W, you can connect a rear speaker lead
directly to a subwoofer without using an auxiliary
amp.
Initially, navigation unit is set for rear full-range
speaker connection (REAR SP FULL). When
rear output is connected to full range speakers
(when REAR SP FULL is selected), you can con-
nect the RCA subwoofer output to a subwoofer.
In this case, you can select whether to use the
subwoofer controller’s (low pass filter, phase)
built-in PREOUT SUB. W or the auxiliary
PREOUT FULL.
1
Touch “REAR SP” in the INITIAL menu.
2
Touch “REAR SP” to switch the rear out-
put setting.
When no subwoofer is connected to the rear
output, select FULL.
When a subwoofer is connected to the rear
output, select SUB. W.
❒ When the rear output setting is SUB. W,
you cannot change the subwoofer control-
ler.
3
Touch “PREOUT” to switch the sub-
woofer output or non fading output.
❒ Even if you change this setting, there is no
output unless you turn “NON FADING” or
“SUB WOOFER” in the AUDIO menu
“ON”.
➲ Using non fading output ➞ Page 99
➲ Using subwoofer output ➞ Page 99
❒ If you change the subwoofer controller
(REAR SP), the subwoofer output (SUB
WOOFER) and non fading output (NON
FADING) in the AUDIO menu return to
the factory settings.
❒ Both rear speaker leads output and RCA
rear output are switched simultaneously in
this setting.
Switching the muting/attenua-
tion
When the navigation outputs the guidance voice,
or when a mute signal has been received from
the yellow/black lead connected to the navigation
unit (e.g. using a cellular telephone), the audio
volume is muted or attenuated.
This function is activated in the following
condition:
— When “MUTE” or “ATT” is selected in this
setting.
— When “On” is selected in “Voice Guid-
ance” on “Mute Settings”.
➲ Mute Settings ➞ Page 63
1
Touch “TEL/GUIDE” in the INITIAL
menu.
Each touch of the “TEL/GUIDE” changes the
settings as follows:
• MUTE — Muting
• ATT — Attenuation
• NORMAL — Volume does not change
❒ The sound is turned off, “MUTE” is dis-
played and no audio adjustments are pos-
sible.
❒ The sound is attenuated, “ATT” is dis-
played and no audio adjustments, except
volume control, are possible.
❒ Operation returns to normal when the
phone connection (the mute signal on the
yellow/black lead) is ended or when the
navigation guidance is ended.
❒ Even when you receive a phone call, navi-
gation voice guidance cannot be attenu-
ated or muted. Use the Volume to control
the navigation voice guidance volume.
Initial Settings