Pioneer PRO-730HDI - Manual (Page 85)

85
V
ARIOUS FUNCTIONS
REMOTE CODE SET UP
• Buttons which can be learnt are as follows.
CBL ........... SOURCE POWER, CH (+), CH (–), CH
RETURN, CH ENTER, 1 to 9, 0
SAT ........... SOURCE POWER, CH (+), CH (–), |,
\, », «, SET/ENTER, MENU, DTV/
SAT GUIDE, DTV/SAT INFO, CH
ENTER, 1 to 9, 0, DVD TOP MENU
DTV ........... SOURCE POWER, BLUE, RED,
GREEN, YELLOW, |, \, », «, SET/
ENTER, DVD TOP MENU, CH (+),
CH (–), 1 to 9, 0, CH ENTER, •(DOT),
CH RETURN, DTV/SAT INFO, DTV/
SAT GUIDE
VCR ........... SOURCE POWER, CH (+), CH (–), 8,
1, 7, 3, ¡, ¶
DVD .......... SOURCE POWER, RETURN, ¢,
4, 8, 1, 7, 3, ¡, |, \, », «,
SET/ENTER, MENU, DVD TOP
MENU
DVR .......... SOURCE POWER, ¢, 4, 8, 1,
7, 3, ¡, CH (+), CH (–), ¶, REC
STOP
• CBL/SAT/DTV and DVD/DVR cannot be selected
at the same time.
3
Face the remote control unit of the other
manufacturer's and the remote control
unit of the Monitor to each other, and
press the POWER button of the remote
control unit of the other manufacturer's.
Leave about 0.8 to two inch (2 to 5 cm) between the two remote
control units.
If you learn how to use the remote control unit you can adjust the
distance of the remote control units.
0.8 to 2.0 inch
(2 to 5 cm)
(VCR)
POWER
• If blinks once, return to
step 2 for other buttons.
• Flashes four times, it
indicates an error has
occurred.
• This ends learn.
Repeat steps 2 and 3 for learning pertaining to other VCR
devices.
• If the remote control unit’s LED blink four times, it means that
learning capacity has reached its maximum and no more
learning will be possible.
4
When the LEARN button is pressed, the
remote control unit return to normal
states.
NOTES:
• To stop using the LEARN mode in the middle, press
the LEARN button again.
• If mode switch is switched while in LEARN mode,
LEARN mode will be canceled.
• After steps 1 and 2, if you do not press the button
for one minute (no operation), the LEARN mode
will be canceled.
• To reset the learn setting, have the LED blinking as
in step 1 and then keep the remote control unit’s
TV POWER button pressed for at least 2 seconds.
• There are some remote controls which cannot
learn.
LED will blink.
ARB1557A_En_081_091.P65 8/10/03, 09:30 85