Pioneer PRO-730HDI - Manual (Page 39)

39
BASIC FUNCTIONS
CHANGING PASSWORD
3
MENU END SET SET SELECT
c c
C H A N G E P A S S WO R D
I N P U T Y O U R P A S S WO R D
E X I T
– – – –
A password must be entered to turn program blocking on and off. The
default password is '1234', but it is strongly recommended that you change
the password.
1
Press MENU and select SET UP by using
the
| or \ button and then pressing «
button. (Refer to page 26.)
2
Select CHANGE PASSWORD in the same
way.
MENU END SET SET SELECT
S E T U P
c c
C O N V E R G E N C E
P R O G R A M B L O C K
S Y S T E M I N / O U T
D I G I T A L I N T E R F A C E
C H A N N E L S E T U P
C H A N G E P A S S WO R D
Enter current password.
• Press numeric buttons ‘0’ through ‘9’ to enter a four digit
password.
• If no password has been previously set, enter the default
password of ‘1234’.
Cut along dotted line and file after reading and filling out.
If you forget the password
When the message ‘INPUT YOUR PASSWORD’ in step 3 is
displayed, press the RESET button on the front panel and hold it
down for 3 seconds or longer.
The password reverts to “1234”.
◊B√¿≥≤?ÙÛc ◊B√¿.≤?ÙÛc
Your PROGRAM BLOCK password No.:
○○○○○○○○○○
○○○○○○○○○○○○○
○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○
We suggest you write down your password so you don't forget it.
ARB1557A_En_032_040.P65 8/8/03, 16:49 39