Pioneer PRO-730HDI - Manual (Page 10)

10
NOTES FOR CARE AND CLEANING OF SCREEN:
• Do not hit or throw anything onto the protective screen, as a
damaged protective screen may cause injury.
• If the protective screen surface is dirty, wipe it with a cloth
dipped in warm water and then wrung out. Wipe it dry with
a soft, dry cloth.
• Never use paint thinner or other cleaners to clean the
protective screen as they may contain harmful chemicals
that will damage the finish of the screen.
HOW TO REMOVE THE FRAME COVER
Remove the frame cover by the following procedure.
1 Prepare a flat–blade screw driver (large) and a small and
thick cloth.
2 Wrap the flat–blade screw driver into the end of the side
frame covers (left and right) and remove it using a lever
principle. Be sure to remove them from the bottom as
shown in the figure.
HOW TO ATTACH THE PROVIDED
FRAME COVER
PARTS INCLUDED FOR FRAME COVER INSTALLATION:
2 SIDE FRAME COVERS (L, R) (TRIMS) (short)
2 FRAME COVERS (TRIMS) (long)
HOW TO ATTACH THE FRAME COVER
ATTACH THE FRAME COVER BEFORE USING THE MONITOR.
1. Attaching the side frame covers.
Push in the side frame cover from the outside along the
groove on the panel frame until you hear a click.
Attach side frame cover along the aluminium edge guards
leaving a space of approximately 0 to 1/32 in. (0 to 1 mm)
from the upper panel frame.
2. Attaching the upper and lower frame covers
Push in the upper and lower frame covers from the outside
along the groove on the panel frame until you hear a click.
Upper panel
frame
Side frame
cover
Screen frame
Screen frame
Upper panel frame
0 to 1 mm
(0 to 1/32 in.)
Side frame cover
Attach
Frame cover
Side frame cover (L)
Attach
Side frame cover (R)
Attach
Attach
3 Remove the upper and lower frame covers by the same
procedure as in 2, gently.
Side frame cover (L) Side frame cover (R)
Upper frame cover Lower frame cover
ARB1557A_En_007_011.P65 8/8/03, 16:34 10