Pioneer PRO-730HDI - Manual (Page 11)

11
INTRODUCTION
If you decide remove the protective screen.
1. Remove the left, right, upper, and lower frame covers.
2. Remove the screws from the upper panel frame and side
panel frames. (Not remove the screw from the lower panel.)
The protective screen is attached when the monitor is shipped to protect the display. We do not recommend that you remove it, but
if you have to remove it, do so following the procedure shown below.
3. While holding the screen in place, remove the upper panel
frame and side panel frames.
CAUTION:The panel frames are made of aluminum, so to
protect them from scratches, be extremely careful not to
strike them with the rim of the screen frame.
5. Remove the screws from the lower panel frame.
4. Remove the protective screen from the lower panel frame.
6. Reattach upper, lower and side panel frames as indicated
then follow on HOW TO ATTACH THE FRAME COVER.
Screw
Side panel
frame (L)
Side panel
frame (L)
Protective
screen
Lower
panel frame
Side view
Screw
When the protective screen is
attached. When the protective screen is not
attached.
(Attach the panel frames reversed
as shown in the figure.)
Panel frame
Panel frame
Protective screen
Upper panel frame
HOW TO REMOVE THE PROTECTIVE
SCREEN
ARB1557A_En_007_011.P65 8/8/03, 16:34 11