Pioneer PDP-507XD - Manual (Page 60)

60
En
Enjoying through External Equipment 12
NOTE
• If you select a parameter other than “Auto”, make such a
setting that results in natural colour.
• If no image appears, specify another digital video signal type.
• For the digital video signal types to be specified, check the
operation manual that came with the connected equipment.
To specify the type of audio signals:
When you use the INPUT 3 HDMI terminal, use the following
procedure to specify the type of audio signals.
1
Repeat steps 1 to 3 provided for “ To activate the HDMI
terminal.”
2
Select “Audio” ( / then ENTER).
3
Select the type of audio signals ( / then ENTER).
• If you select “Auto”, an attempt will be made to identify
the type of audio signals when audio signals are
received.
4
Press HOME MENU to exit the menu.
NOTE
• The INPUT 4 HDMI terminal accepts only digital audio
signals.
• If no sound is output, specify another audio signal type.
• For the audio signal types to be specified, check the
operation manual that came with the connected equipment.
• Depending on the equipment to be connected, you also need
to connect analogue audio cables.
Using i/o link.A
The Plasma Television incorporates three typical i/o link.A
functions for smooth connections between Plasma Television
and other audiovisual equipment.
One Touch Play
While the Plasma Television is in standby mode, it
automatically turns on and plays back images from the
audiovisual source (e.g. VCR, DVD).
WYSIWYR (What You See Is What You Record)
When the remote control unit of the connected VCR has the
WYSIWYR button, you can automatically start recording by
pressing the WYSIWYR button.
Preset Download
Automatically transfers channel preset information from the
tuner on the Plasma Television to the one on the connected
audiovisual equipment (e.g. VCR) via the INPUT 2 or 3 terminal.
To select the SCART terminal which is available for
i/o link.A:
Select the INPUT terminal to which the recording equipment
(e.g. VCR) you use has been connected.
1
Press HOME MENU.
2
Select “Setup” ( / then ENTER).
3
Select “i/o link.A” ( / then ENTER).
4
Select the desired parameter ( / then ENTER).
5
Press HOME MENU to exit the menu.
NOTE
• The i/o link.A functions work only when the audiovisual
equipment is connected to the INPUT 2 or 3 terminal on the
Plasma Television with i/o link.A via a fully wired 21-pin
SCART.
• Refer to operation manuals of each external equipment for
the details.
• If a SCART cable has been connected to the INPUT 3
terminal with the i/o link.A activated, input signals (other
than Component) are automatically identified and displayed.
If the i/o link.A has been deactivated, Video is always
selected for signals other than RGB because the system
cannot identify among RGB, Y/C (S-Video), and CVBS (Video)
signals; for example, receiving Y/C (S-Video) signals results
in monochrome display.
Item Description
Auto
(factory default) Automatically identifies input audio signals.
Digital Accepts digital audio signals.
Analogue Accepts analogue audio signals.
Item Description
INPUT 2
(factory default) INPUT 2 is available for i/o link.A.
INPUT 3 INPUT 3 is available for i/o link.A.
Plasma Television (rear view)
SCART cable
(commercially available)
VCR or DVD/HDD
Recorder (DVR)