Pioneer PDP-507XD - Manual (Page 45)

45
En
Enjoying DTV broadcasts 09
En
gl
is
h
Displaying technical information
Use this function to check the hardware/software version
number.
1
Repeat steps 1 to 4 provided for “ Using Auto Update”.
2
Select “Technical Information” ( / then ENTER).
NOTE
• You can select “DTV Setup” only when watching DTV
channels.
Using MHEG application (UK only)
Some stations bring you programmes with the MHEG
(Multimedia and Hypermedia Expert Group) application
encoded, letting you experience DTV interactively.
When provided, the MHEG application will start when you
press any of the colour buttons or
m.
NOTE
• This function is not available when subtitle is activated (see
page 39).
Screen Saver
The screen saver automatically starts when no operation is
performed for 3 minutes while receiving DTV radio channels.
NOTE
• While the screen saver is active, you can perform the
following operations:
• Press TV/DTV to switch to analogue TV.
• Press any other button to switch to the normal radio
channel screen.
• Programme Timer is active while the screen saver is
displayed.
Common Interface
To receive scrambled DTV signals you will need a CA module
and a smart card provided by the service provider.
Although CA module types may vary depending on the
manufacturer, each one of the CA modules supports a certain
kind of encryption system. Your Plasma Television supports CA
modules which are made to work with the DVB standard.
Contact a service provider for the right type of CA module.
Please note that a smart card may only be valid for a single
service provider and due to this, a specific range of channels.
NOTE
• CA modules and smart cards are neither supplied nor
optional accessories from PIONEER.
After inserting a card, leave it in the slot permanently. Do not
remove it from the terminal unless asked to do so. For instance,
your card has to be in the slot when your service provider wants
to download new information to the smart card.
Installing a CA module and smart card
Common Interface slot is located at the rear of the Plasma
Television.
1
Hold and push the tab of the slot cover on the rear of the
Plasma Television leftward (a), and remove the cover while
pulling the tab’s latch downward (b).
2
Insert the specified CA module containing a smart card
into the Common Interface slot as far as it will go.
Displaying information about the installed CA
module
If you have installed a CA module in the Common Interface
slot, you can display information about the CA module.
1
Press HOME MENU.
2
Press “Setup” ( / then ENTER).
3
Select “DTV Setup” ( / then ENTER).
4
Select “DVB-CI Information” ( / then ENTER).
(If there is no CA module installed, the “DVB-CI
Information” option is greyed out.)
a
b
Tab
COMMO
N INTER
FACE
CA module
Smart card