Polycom RMX 2000 - Manual (Page 18)

Chapter 2-First Time Installation and Configuration
2-4
Gather Network Equipment and Address
Information
IP Services
The IP addresses and network parameters which enable communication
between the RMX, its management application and the conferencing
devices are organized in two IP services:
•
Management Network (Control Unit)
• Default IP Service (Conferencing Service)
During the First Entry Configuration, the parameters of these two network
services are modified to comply with your local network settings.
Management Network
The Management Network enables communication between RMX Control
Unit and the RMX Web Client and is used to manage the RMX.
Default IP Service (Conferencing Service)
The Default IP Service (Conferencing Service) is used to configure and
manage communications between the RMX and conferencing devices.
The RMX is shipped with default IP addresses as listed in Table 2-1.
When installing an RMX unit, these default IP addresses must be
modified to your local network settings. Therefore it is important that
before powering the RMX unit up for the first time, that you obtain the
information needed to complete the Local Network Settings section of
the table from your network administrator.
Hardware
Installation
and
Setup
Gather Network
Equipment
and
Address Info
First Entry
Configuration
Table 2-1 Network Equipment and Address Information
Parameter Factory Default Local Network Settings
Control Unit
IP Address 192.168.1.254
Control Unit
Subnet Mask 255.255.255.0