Polycom RMX 2000 - Manual (Page 15)

2-1
2
First Time Installation and
Configuration
First Time Installation and Configuration of the Polycom RMX 2000
consists of the following procedures:
1
Hardware Installation and Setup
—
Mount the RMX in a rack.
— Connect the necessary cables.
2 Gather Network Equipment and Address Information
— Get the information needed for integrating the RMX into the
local network.
3 First Entry Configuration
—
Power up and register the RMX.
—
Modify the Management Network.
—
Configure the Default IP Service.
Hardware Installation and Setup
The RMX unit should be mounted in a 19”rack in a well ventilated area. It
is important to adhere to the Site Requirements as described in the RMX
2000 Hardware Guide, "Site Requirements” on page 1-3 .
Mounting the RMX in a Rack
There are two methods for installing the RMX in a rack:
•
Using rack brackets – Install rack brackets, supplied by the rack
manufacturer, in the rack. Mount the RMX on top of the rack
Hardware
Installation
and
Setup
Gather Network
Equipment
and
Address Info
First Entry
Configuration