Panasonic DMC-LZ7 - Manual (Page 39)

Advanced (Recording pictures)
39
VQT1C60
• When the shutter speed is fast, the flash
effect may not be sufficient.
• It may take time to charge the flash if you
repeat taking a picture. Take a picture
after the access indication disappears.
• The red-eye reduction effect differs
between people. Also, if the subject was
far away from the camera or was not
looking at the first flash, the effect may not
be evident.
• When the flash is activated, you can only
take 1 picture.
Taking Pictures with
the Self-timer
1 Press 2 [ ].
2 Press 3/4 to select a mode.
• You can also press 2 [ ] to select.
3 Press [MENU/SET].
• You can also press the shutter
button halfway to finish.
• The menu screen disappears after
about 5 seconds. At this time, the
selected item is automatically set.
4 Press the shutter button halfway
to focus and then press it fully to
take the picture.
• A: Press the shutter button halfway to
focus.
• B: Press the shutter button fully to take
the picture.
• The self-timer indicator C blinks and
the shutter is activated after 10 seconds
(or 2 seconds).
• If you press [MENU/SET] while the
self-timer is set, the self-timer setting is
cancelled.
• When using a tripod etc., setting the self-timer
to 2 seconds is a convenient way to avoid the
jitter caused by pressing the shutter button.
• When you press the shutter button once fully,
the subject is automatically focused just before
recording. In dark places, the self-timer
indicator will blink and then may turn on
brightly operating as an AF assist lamp (P62)
to allow the camera to focus on the subject.
• In simple mode [ ], the self-timer is fixed
to 10 seconds.
• When you set the self-timer in burst mode,
the camera starts taking a picture 2 or
10 seconds after the shutter button is
pressed. The number of pictures taken at
one time is fixed to 3.
• We recommend using a tripod when
recording with the self-timer.
OFF
SET SELECT MENU
2 SEC.
10 SEC.
SELFTIMER
CANCEL
3
MENU
VQT1C60ENG.book 39 ページ ２００７年１月１１日 木曜日 午後６時４９分